In the recent era, the High Speed Crafts (HSCs) industry in the Philippines has been consisted only of Fastcrafts and Catamarans (which are colloquially called “FCs” and “cats”). In the earlier years though we had Hydrofoils like the “Flying Fish” which sailed in Manila Bay. One extant but non-running example of a hydrofoil here is in Ouano in Cebu but it cannot yet be identified at the moment.
Fastcrafts are monohulled vessels with overpowered engines to give them high speeds. On the other hand, catamarans are twin-hulled and some are even triple-hulled and these are sometimes called as trimarans. We also had such examples here of that in the Jumbo Cats of Universal Aboitiz.
Many High Speed Crafts have aluminum alloy hulls to lessen weight and thus increase the ‘power to weight ratio’ to give them better speed. Our HSCs are not big and they are among the smallest in the world. We do not have a High Speed Craft that can carry vehicles.
Fastcrafts usually have propellers (screws) as means of propulsion. Catamarans, however, can have propellers or water jets. The latter type is no longer preferred here since water jets has a higher fuel consumption rate compared to propellers. Additionally, water jets are prone to fouling due to the rubbish and flotsam found in the waters of or near our ports.
In general, catamarans are faster than fastcrafts since one advantage of twin hulls is the lower water resistance. The speed advantage is more pronounced with the use of water jets. However, there are some fastcrafts that can give ‘cats’ a good run for their money and sometimes speed races between the two happen especially when the cost of fuel was not yet high.
The catamarans, being wider, can carry more passengers than fastcrafts. However, their center of gravity is higher and if there is no motion dampening system the ‘cats’ roll (‘sway’ in layman’s term) more. It does not mean, however, that they are less safe but some passengers are more prone to motion sickness.
Fastcrafts in the country are mainly of two different designs. The more numerous are the fastcrafts made in Malaysia which were derived from a riverboat design. They were mainly built by several yards in Borneo with fastcraft-building centering in Sibu. The Malaysian FCs are long and sit low and have steel hulls. If crippled, a Malaysian FC can be tied to another and not towed. On a rough sea, waves will pass over its roof and splash on its windows and the craft will rock a little but sitting low nausea does not easily set in. it is actually a formula for a good sleep. Many doubted the Malaysian FCs at the start but when tried on a choppy sea it is then people realize they are more stable.
The other design of our fastcrafts come from Japan and they are based on the motor launch. Many are aluminum alloy or FRP-hulled (FRP is Fiberglass Reinforced Plastic) and both are light compared to steel. One disadvantage though of an FRP hull is in the event of an engine fire, the hull simply melts and none are almost saved from sinking. Like aluminum alloy hulls, when burning, FRP hulls produce noxious fumes. Montenegro Lines operates the most number of ex-Japan fastcrafts in the Philippines. Many of the Japanese fastcrafts here are actually sister ships having come from one basic design.
There is also a third fastcraft design used in the country, the ones that came from Hongkong which looks like an oversized boat. It has good passenger capacity but with a wide hull it cannot match the Malaysian fastcrafts in speed. Only Oceanjet uses this type of fastcraft in the Philippines, the Oceanjet 3, 5 and 6.
Recently a new type of Fastcraft showed in the country, the Australian type which was built from kits sent here and assembled by Golden Dragon Fastcraft Builder in Labogon, Mandaue, Cebu. The examples are Oceanjet 8, 88 and 888 with another still being assembled and expected to be completed in the year 2015.
The primary exponent of catamarans in the country was the old Universal Aboitiz as represented by the SuperCat series. Aboitiz even established FBM Aboitiz Marine to build catamarans of Australian design in Balamban, Cebu. They sold this shipyard now to Austal but the facility still build ships including catamarans of Australian design which are meant for the international market (the local market can no longer afford such brand-new catamarans).
Most of the Aboitiz SuperCats are gone now along with its former competitors — the Sea Angels of Negros Navigation and the Waterjets together with many competitors that tried the Batangas-Mindoro and Iloilo-Bacolod routes. The SuperCats recently passed on to 2GO in the merger of Negros Navigation and Aboitiz Transport System and they have since been renamed into saints.
Gone too were most of the other shipping companies that tried catamarans in the ‘90s along with their crafts and routes. Among them are Prestige Cruises (operator of the Mt. Samat catamarans), El Greco Jet Ferries, ACG Express Liner (operator of the SeaCats), Royal Ferry, etc. The short-lived HSC boom happened when the price of fuel was still low. It seems the companies simply overestimated the market and maybe forgot most of the riding public are poor and will not readily pay double the fares of the ROPAXes. Even the boom of tourism in the recent years was not enough to lift our HSC sector. It was still the short-distance ferry-ROROs that thrived.
Magsaysay Lines through Sun Cruises also operate cruise tours using High Speed Crafts from Manila to Corregidor.
The biggest remaining operators of High Speed Crafts nowadays are Oceanjet Fast Ferries, 2GO, Weesam Express (SRN Fastcrafts), Starcrafts and Montenegro Lines. Lite Ferries recently entered this field and they now have three HSCs with two of them Hongkong examples but different from that used by Oceanjet.
These are also several High Speed Crafts laid up in Manila, Lucena and Cebu and most of them are no longer in sailing condition. Most were victims of the HSC wars in the Batangas-Mindoro routes.
The Philippines has no formal definition of what is a High Speed Craft but in other countries HSCs are vessels that run faster than the ROPAXes. Our fastest ROPAXes sail at 20 knots and so the Philippine Ship Spotters Society (PSSS) has adopted 20 knots as the minimum speed to be considered a High Speed Craft. Older HSCs no longer capable of this speed are then downgraded into Medium Speed Crafts (MSCs). There are also vessels that came into the Philippines as original MSCs not capable of 20 knots and the prime examples of these are the sister ships Anika Gayle, Anika Gayle 2 and Anstephen. The Kinswell crafts were MSCs too.
Though this sector is not growing it won’t go away, however. Maybe the recent collapse of the oil prices might see a renaissance if the price holds steady at the low level. Otherwise, the only hope is if the shipping companies can import fuel from Singapore tax-free but that is just like shooting for the moon or the stars. If this is not possible then the only hope will be is when the real income of the Filipinos go high enough so they will look for and be able to afford better sea crafts than they are used to. But then that will still be at least one generation away or even two given the glacial pace of change in this country.